Panasonic PT-RQ22K

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 67
Switching on/off the projector
Connecting the power cord
Make sure that the supplied power cord is securely xed to the <AC IN> terminal of the projector to
prevent it from being removed easily.
Conrm that the <MAIN POWER> switch is on the <OFF> side before connecting the supplied power cord.
Use the power cord matching with the power supply voltage and the shape of the outlet.
For details of power cord handling, refer to “Read this rst!” (x page 5). For the shape of the outlet, refer to
“Usable outlet” (x page 40).
Note
f The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.
f The supplied power cords vary depending on the country or region where you purchased the product.
How to attach the power cord
For India
1) Check the shapes of the <AC IN> terminal on the side of the projector and the power cord connector,
then insert the connector completely in the correct direction.
For other countries or regions
Fig. 3Fig. 2Fig. 1
Power cord holder
1) Confirm that the power cord holder is raised so that the power cord can be inserted. (Fig. 1)
2) Check the shapes of the <AC IN> terminal on the side of the projector and the power cord connector,
then insert the connector completely in the correct direction. (Fig. 2)
3) Lower the power cord holder so it snaps onto the power cord, and fix the power cord. (Fig. 3)
How to remove the power cord
For India
Lock button
1) Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal of the projector while pressing the lock
button.