Chapter 1 Preparation — About your projector
ENGLISH - 31
Projector body
1 2 3
4
5
6 67
77
7
14 15
10 11
139
8
12
Front
Side
Rear
16
Projection direction
Bottom
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT1>
Indicates the status of light source 1.
4 Light source indicator <LIGHT2>
Indicates the status of light source 2.
5 Temperature indicator <TEMP>
Indicates the internal temperature status.
6 Adjustable feet
Adjusts the projection angle.
7 Air intake port
8 Remote control signal receiver (rear)
9 Air exhaust port
10 Control panel (x page 32)
11 Connecting terminals (x page 33)
12 Security slot
This security slot is compatible with the Kensington security
cables.
13 Power cord holder
(Except for PT-RQ22KD)
Connect the supplied power cord.
15 <MAIN POWER> switch
Turns on/off the main power.
16 Security bar
A wire, etc., can be attached to prevent theft.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
To Next Page
Loading...
