Chapter 4 Settings — [SECURITY] menu
ENGLISH - 199
4) Press the <ENTER> button.
f The [CONTROL PANEL] screen or the [REMOTE CONTROL] screen is displayed.
5) Press as to select [CONTROL PANEL] or [REMOTE CONTROL].
6) Press qw to switch [USER].
7) Press as to select the button item to set.
f When [INPUT SELECT BUTTON] is selected, press the <ENTER> button, and then press as to select
the button to set.
Buttons that can be set
[CONTROL PANEL] [REMOTE CONTROL]
[POWER BUTTON]
Power standby <v> button, power on <b> button
[INPUT SELECT BUTTON]
<SDI 1/2> button, <SDI 3/4> button, <DIGITAL
LINK> button, <SLOT 1> button, <SLOT 2>
button, <INPUT MENU> button
<DVI-D> button, <HDMI> button, <SDI> button,
<DIGITAL LINK> button, <SLOT 1> button,
<SLOT 2> button, <INPUT MENU> button
[MENU BUTTON] <MENU> button
[LENS BUTTON] <LENS> button Lens buttons (<FOCUS>, <ZOOM>, <SHIFT>)
[AUTO SETUP BUTTON] <AUTO SETUP> button
[SHUTTER BUTTON] <SHUTTER> button
[ASPECT BUTTON] ― <ASPECT> button
[ON SCREEN BUTTON] ― <ON SCREEN> button
[OTHER BUTTON]
asqw, <ENTER> button
Buttons not listed above
8) Press qw to switch the item.
[ENABLE] Enables button operations.
[DISABLE] Disables button operations.
f When [INPUT SELECT BUTTON] is selected in Step 7), the item that can be set varies depending on the
selected button.
Refer to “Item that can be set with [INPUT SELECT BUTTON]” (x page 199) for details.
Once the switching of the item is completed, press the <MENU> button to return to the [CONTROL PANEL]
screen or the [REMOTE CONTROL] screen.
9) Press as to select [APPLY], and press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f When a button operation is performed on the device set to [DISABLE], the [CONTROL DEVICE PASSWORD] screen is displayed.
Enter the control device password.
f The [CONTROL DEVICE PASSWORD] screen will disappear when there is no operation for approximately 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f Even when you set button operations on the remote control disabled, operations of the <ID SET> and <ID ALL> buttons on the remote
control are kept enabled.
Item that can be set with [INPUT SELECT BUTTON]
When [INPUT SELECT BUTTON] is selected in Step 7) of “Enabling/disabling any button” (x page 198), the
item that can be selected varies depending on the button to set.
The item that can be selected when each button is set is as follows.
r [SDI1/2 BUTTON]
[TOGGLE] Switches between [SDI1] and [SDI2] when the button is operated.
[SDI1] Fixes to selection operation of the SDI1 input.
[SDI2] Fixes to selection operation of the SDI2 input.
[DISABLE] Disables button operations.
To Next Page
Loading...
