Panasonic PT-RQ32K

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 117
5) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Automatically select [SQUARE] or [INTERLEAVE].
[SQUARE] or [INTERLEAVE] is automatically selected by reading the payload ID attached to the
input signal.
[SQUARE] Fixes the transmission method to Square Division.
[INTERLEAVE] Fixes the transmission method to 2-Sample Interleave Division.
Setting [3G-SDI MAPPING] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f When [QUAD LINK SETTING] is selected, proceed to Step 5).
4) Press as to select [SDI1], [SDI2], [SDI3], [SDI4], [SDI1-2], or [SDI3-4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] screen or [DUAL LINK SETTING] screen for the selected item is displayed.
5) Press as to select [3G-SDI MAPPING].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically select [LEVEL A] or [LEVEL B].
[LEVEL A] Fixes the mapping method to 3G-SDI Level-A.
[LEVEL B] Fixes the mapping method to 3G-SDI Level-B.
Note
f This function does not operate when the SD-SDI signal or the HD-SDI signal is input.
f [3G-SDI MAPPING] cannot be set when [SDI LINK] is set to [AUTO].
Setting [SYSTEM SELECTOR] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f When [QUAD LINK SETTING] is selected, proceed to Step 5).
4) Press as to select [SDI1], [SDI2], [SDI3], [SDI4], [SDI1-2], or [SDI3-4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] screen or [DUAL LINK SETTING] screen for the selected item is displayed.
5) Press as to select [SYSTEM SELECTOR].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Automatically selects [RGB], [YP
B
P
R
4:4:4], [YP
B
P
R
4:2:2], or [XYZ].
[RGB], [YP
B
P
R
4:4:4], [YP
B
P
R
4:2:2], or [XYZ] is automatically selected by reading the payload ID
attached to the input signal. [RGB] is selected when the payload ID is not attached to the input signal.
[RGB] Fixes to [RGB].