Panasonic PT-RZ21K

Chapter 4 Settings — [3D SETTINGS] menu
ENGLISH - 113
[3D COLOR MATCHING]
Switch the color matching correction data applied to displayed image.
1) Press as to select [3D COLOR MATCHING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[SHARED 2D/3D] Uses same correction data for 2D signal and 3D signal.
[SEPARATE 2D/3D] Uses different correction data for 2D signal and 3D signal.
Note
f Switch the setting of [COLOR MATCHING] (x page 116) while the signal to be adjusted is being input.
[3D PICTURE BALANCE]
Correct the difference when the images for left eye and right eye have different brightness or color.
1) Press as to select [3D PICTURE BALANCE].
2) Press the <ENTER> button.
f The [3D PICTURE BALANCE] screen is displayed.
3) Press as to select an item, and press qw to adjust the setting.
f Using the left eye image as a reference, the right eye image is corrected using the set value.
f For [3D WAVEFORM MONITOR], the images for the left eye and right eye are split horizontally on the left
and right, and waveforms are displayed.
[CONTRAST] Adjusts the contrast of colors.
[WHITE BALANCE HIGH
RED]
Adjusts the red color of the white balance high.
[WHITE BALANCE HIGH
GREEN]
Adjusts the green color of the white balance high.
[WHITE BALANCE HIGH
BLUE]
Adjusts the blue color of the white balance high.
[BRIGHTNESS] Adjusts the dark (black) part of the projected image.
[WHITE BALANCE LOW RED] Adjusts the red color of the white balance low.
[WHITE BALANCE LOW
GREEN]
Adjusts the green color of the white balance low.
[WHITE BALANCE LOW
BLUE]
Adjusts the blue color of the white balance low.
[COLOR] Adjusts the color saturation.
[TINT] Adjusts the skin tone in the projected image.
[CLOCK PHASE] Adjusts the image when there is ickering in the image or blur of the outline.
[3D WAVEFORM MONITOR]
[OFF] Does not display the 3D waveform monitor.
[ON] Displays the 3D waveform monitor.
Note
f The [CLOCK PHASE] setting is enabled during simultaneous input of RGB1 and RGB2, and is adjusted against the right eye image.
f This function is disabled when [3D SYSTEM SETTING] is set to anything other than [SINGLE].
f This function is disabled when [3D TEST PATTERN] is displayed.
f This function is disabled when [3D TEST MODE] is set to anything other than [NORMAL].
f The 3D waveform monitor is displayed only when the [3D PICTURE BALANCE] screen is displayed.
f The normal waveform monitor cannot be displayed when the 3D image is displayed.
[DARK TIME SETTING]
Set the black display period that is displayed between the right eye image and the left eye image to match the 3D
system in use.
1) Press as to select [DARK TIME SETTING].
2) Press qw to switch the item.
f The items will switch each time you press the button.