Panasonic PT-RZ21K

Chapter 4 Settings — [PROJECTOR SETUP] menu
166 - ENGLISH
1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 232)
[USER] Changes the setting of the <REMOTE 2 IN> terminal.
f When [USER] is selected, proceed to Step 3).
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE] Disables the <FUNCTION> button.
[P IN P]
Switches the [P IN P] setting ([OFF], [USER1], [USER2], or [USER3]). (x page 171)
[SUB MEMORY]
Displays the sub memory list. (x page 176)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than SDI1 input or SDI2 input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 97)
f When the input signal is SDI1 input or SDI2 input
g The [DISPLAY OPTION] menu → [SDI IN] → [SINGLE LINK SETTING] → [SDI1]/[SDI2] →
[SYSTEM SELECTOR] (x page 128)
g The [DISPLAY OPTION] menu → [SDI IN] → [DUAL LINK SETTING] → [SYSTEM SELECTOR]
(x page 128)
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 94)
[FREEZE]
Temporarily pauses the image. (x page 135)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (x page 135)
[LENS MEMORY LOAD]
Loads the registered lens memory. (x page 141)
[LEFT/RIGHT SWAP]
Switches the [LEFT/RIGHT SWAP] setting. (x page 112)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (x page 138)
4) Press the <ENTER> button.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE] Displays the type of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source 1 and the light source 2.
[CONTINUOUS LIGHTING
TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be conrmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.