Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 59
Switching on/off the projector
Connecting the power cord
To prevent disconnection of the power cord, use the supplied power cord and securely insert all the way
in to x it.
Conrm that the <MAIN POWER> switch is on the <OFF> side before connecting the supplied power cord.
Use the power cord matching with the power supply voltage and the shape of the outlet.
For details of power cord handling, refer to “Read this rst!” (x page 5). For the shape of the outlet, refer to
“Usable outlet” (x page 36).
Note
f The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.
f The supplied power cords vary depending on the country or region where you purchased the product.
How to attach the power cord
1) Check the shapes of the <AC IN> terminal on the side of the projector and the power cord connector,
then insert the connector completely in the correct direction.
How to remove the power cord
Lock button
1) Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2)
Remove the power cord connector from the <AC IN> terminal of the projector while pressing the lock
button.
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status Projector status
Off The main power is switched off.
Red Lit
The power is switched off. (standby mode)
Projection will start when the power on <b> button is pressed.
f The projector may not operate when the light source indicators <LIGHT1>/<LIGHT2>
or the temperature indicator <TEMP> are blinking. (x page 209)
To Next Page
Loading...
