Chapter 1 Preparation — About your projector
30 - ENGLISH
Projector body
1 2 3
4
5
6 67
77
7
13 14
10 11
9
8
12
Front
Side
Rear
15
Projection direction
Bottom
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT1>
Indicates the status of light source 1.
4 Light source indicator <LIGHT2>
Indicates the status of light source 2.
5 Temperature indicator <TEMP>
Indicates the internal temperature status.
6 Adjustable feet
Adjusts the projection angle.
7 Air intake port
8 Remote control signal receiver (rear)
9 Air exhaust port
10 Control panel (x page 31)
11 Connecting terminals (x page 32)
12 Security slot
This security slot is compatible with the Kensington security
cables.
Connect the supplied power cord.
14 <MAIN POWER> switch
Turns on/off the main power.
15 Security bar
A wire, etc., can be attached to prevent theft.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
To Next Page
Loading...
