Panasonic PT-RZ21K

Chapter 6 Maintenance — Troubleshooting
ENGLISH - 213
Problems Points to be checked Page
Lens shift cannot be
adjusted.
f Perform [LENS CALIBRATION]. 72
f Is the Fixed‑focus Lens (Model No.: ET‑D75LE50) attached? ―
Cannot control the
projector with Art-Net.
f Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
―
f Is [Art-Net SETUP] set to other than [OFF]? 183
f Are [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] set correctly? 183
The DIGITAL LINK input
image is not displayed.
f Is the cable compatible to the condition of the projector used? 55
f Are the connections between the twisted-pair-cable transmitter and the projector or
an external device correctly done?
―
f Is [DIGITAL LINK MODE] set to [AUTO], [DIGITAL LINK], or [LONG REACH]? Is it
set to [ETHERNET]?
181
f Is a signal which is not compatible with a twisted-pair-cable transmitter being input? ―
3D function is not working.
f Is the [3D INPUT FORMAT] setting of [3D SETTINGS] correct? 112
f Check the 3D eyewear settings. ―
f Is a signal which is supported by the projector being input? 242
Left and right images are
reversed (not showing
properly).
f Is it synchronized? Check the 3D eyewear settings. ―
f Change the [LEFT/RIGHT SWAP] setting of [3D SETTINGS]. 112
Image in the 3D eyewear
ickers.
f Are you within the reception range? ―
3D eyewear is not
functioning.
f Is the battery for 3D eyewear dead? Charge the battery for the rechargeable 3D
eyewear. Change the battery for the battery type.
―
f Is the [3D SETTINGS] setting correct? 111
Attention
f If problems persist even after checking the preceding points, consult your dealer.