Wireless LAN (USER 1~USER 3)
1
2
3
4
5
6
7
8
9
10
7
7
1 [DHCP ON], [DHCP OFF]
To enable the DHCP client function, set to [DHCP ON].
2 [IP ADDRESS]
Enter the IP address when not using a DHCP server.
3 [SUBNET MASK]
Enter the subnet mask when not using a DHCP server.
4 [DEFAULT GATEWAY]
Enter the default gateway address when not using a
DHCP server.
5 [DNS1], [DNS2]
Enter the preferred DNS/alternate DNS server when not
using a DHCP server.
6 [SSID]
Enter the same character string that are registered in the
access point.
7 [Back], [Next]
Click the [Back] button to return to the original screen.
The current settings are displayed by pressing the [Next]
button.
Click the [Submit] button to update the settings.
8 [AUTHENTICATION]
Set the user authentication method used by the network
to be connected.
9 [EAP]
Select the EAP setup in the RADIUS server.
10 [ENCRYPTION]
Select the encryption method to be used for
communication between the projector and the network.
Note
f The screen items will change according to the authentication method of wireless LAN which is connected.
[Ping test] page
Check whether the network is connected to the mail server, POP server, DNS server, etc.
Click [Detailed set up] → [Ping test].
1
2
3
4
1 [Input IP address]
Enter the IP address of the server to be tested.
2 [Submit]
Executes the connection test.
3 Example of display when the connection has
succeeded
4 Example of display when the connection has failed
108 -
ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
