f The items will switch each time you press the button.
[AUTO]
Enables the auto setup function when switching signals.
[BUTTON]
Enables the auto setup function only when the <AUTO SETUP/CANCEL> button is pressed.
[SIGNAL SEARCH]
When the power is turned on, this function automatically detects the terminal which signals are input and sets the function to
switch.
1) Press as to select [SIGNAL SEARCH].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables input detection automatically.
[ON]
Enables input detection automatically.
Note
f If the [SIGNAL SEARCH] is set to [ON] when there is no signal input, press the <AUTO SETUP/CANCEL> button on the
remote control or on the control panel, this function automatically detects the terminal to which signals are input and then
switches.
[BACK COLOR]
Set the display of the projected screen when there is no signal input.
1) Press as to select [BACK COLOR].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE]
Displays the entire projection area in blue.
[BLACK]
Displays the entire projection area in black.
[DEFAULT LOGO]
Displays the Panasonic logo.
[USER LOGO]
Displays the image registered by the user.
Note
f To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
f If you do not register the image of the [USER LOGO], the projected image will be displayed in black even if the [BACK
COLOR] is set to [USER LOGO].
[WIDE MODE]
Using this function when displays the incorrect signals input.
1) Press as to select [WIDE MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Displays by judging the signal automatically. Set to this mode normally.
[ON]
When input the wide signal.
[OFF]
When input the 4:3 signal.
[SXGA MODE]
This function is used if the whole projected image is not displayed when SXGA signal is input.
1) Press as to select [SXGA MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Displays by judging the signal automatically. Set to this mode normally.
[SXGA]
Switch the item to [SXGA] or [SXGA+] manually if the whole projected image is not displayed
when SXGA signal is input.
[SXGA +]
ENGLISH
-
75
Chapter 4 Settings - [DISPLAY OPTION] menu
To Next Page
Loading...
