Panasonic PT-VZ575N

Example of network connections via a twisted-pair-cable transmitter
The projector has a function that can receive Ethernet signals from a twisted-pair-cable transmitter together with video and
audio signals via a LAN cable. Connect a LAN cable to the <DIGITAL LINK/LAN> terminal of the projector. (x page 27)
Computer
Projector
LAN cable (straight)
LAN cable (straight)
Hub
LAN cable (straight)
Twisted-pair-cable transmitter
Note
f For the LAN cable between a twisted-pair-cable transmitter and the projector, use a cable that meets the following criteria:
g Compatible with CAT5e or higher
g Shielded type (including connectors)
g Straight-through
g Single wire
f The maximum transmission distance between the twisted-pair-cable transmitter and the projector is 100 m (328’1”). If this
distance is exceeded, image and sound may be disrupted and may cause a malfunction in LAN communication.
f When laying cables between a twisted-pair-cable transmitter and the projector, check that cable characteristics are
compatible with CAT5e or higher using tools such as a cable tester or cable analyzer.
When using a relay connector midway, include it in the measurement.
f Do not use a hub between a twisted-pair-cable transmitter and the projector.
f Do not pull cables forcefully. Also, do not bend or fold cables unnecessarily.
f To reduce the effects of noise as much as possible, stretch out the cables between the twisted-pair-cable transmitter and the
projector without any loops.
f Lay the cables between a twisted-pair-cable transmitter and the projector away from other cables, particularly power cables.
f When installing multiple cables, run them side by side along the shortest distance possible without bundling them together.
f After laying the cables, conrm that the value of [SIGNAL QUALITY] in the [NETWORK/USB] menu → [DIGITAL LINK
STATUS] is displayed in green (indicates normal quality). (x page 89)
f For twisted-pair-cable transmitter of other manufacturers of which the operation has been veried with the DIGITAL LINK
compatible projector, refer to Panasonic website (http://panasonic.net/avc/projector/). Note that the verication for devices
of other manufacturers has been made for the items set by Panasonic Corporation, and not all the operations have been
veried. For operation or performance problems caused by the devices of other manufacturers, contact the respective
manufacturers.
Projector settings
1) Use the LAN cable to connect the projector with computer.
2) Turn on the projector.
3) Press the <MENU> button to display the [NETWORK/USB] menu, and then select [WIRED LAN], and
press the <ENTER> button.
4) Set the detailed setup of [WIRED LAN].
f For details, refer to “WIRED LAN”. (Æ page 89)
Note
f Please conrm with your network administrator before you connect to an existing network.
f The following settings are set before the projector leaves the factory.
[DHCP]
OFF
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
ENGLISH - 99
Chapter 4 Settings - [NETWORK/USB] menu