13
2. SELECTING THE INSTALLATION SITE
2-1. Indoor Unit
AVOID:
● areas where leakage of flammable gas may be expected.
● places where large amounts of oil mist exist.
● direct sunlight.
● locations near heat sources which may affect the performance of the unit.
● locations where external air may enter the room directly. This may cause “condensation” on
the air discharge ports, causing them to spray or drip water.
● locations where the remote controller will be splashed with water or affected by dampness or
humidity.
● installing the remote controller behind curtains or furniture.
● locations where high-frequency emissions are generated.
DO:
● select an appropriate position from which every corner of the room can be uniformly cooled.
● select a location where the ceiling is strong enough to support the weight of the unit.
● select a location where tubing and drain pipe have the shortest run to the outdoor unit.
● allow room for operation and maintenance as well as unrestricted airflow around the unit.
● the limitation of the tubing length between the indoor and the outdoor units should be
referred to the Installation Instructions of the outdoor unit.
● allow room for mounting the remote controller about 1 m off the floor, in an area that is not in
direct sunlight or in the flow of cool air from the indoor unit.
● If the inside of the ceiling is high temperature and high humidity, apply the polyethylene foam
or other materials of minimum thickness of 10 mm or more to the unit.
4-Way Cassette 60 × 60 Type
0.5 m
0.5 m
0.5 m
0.5 m
Obstacles
min. 3 m
min. 1.5 m
min.
0.5 m
Indoor unit
Air outlet, fire alarm
Ceiling
Over 2.2 m
min. 1 m
Wall
min. 0.25 m
01_330918_EU_Eng.indb 13 2021/9/9 11:26:43
To Next Page
Loading...
