59
9-7. Auto Address Setting Using the Remote Controller
Auto Address Setting from the High-spec Wired Remote
Controller (CZ-RTC5B)
(1) Keep pressing the
, and buttons
simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the LCD
display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Sel. Page [ ] Confirm
20:30 (THU)
(2) Press the or button to see each menu.
If you wish to see the next screen instantly, press the
or button.
Select “9. Auto address” on the LCD display and press
the
button.
(3) The “Auto address” screen appears on the LCD
display.
Change the “Code no.” to “A1” by pressing the
or
button.
(4) Select the “O/D unit no.” by pressing the
or button.
Select one of the “O/D unit no.” by pressing the
or button and press the
button for auto address setting.
Approximately 10 minutes are required.
When auto address setting is completed, the units return to normal stopped status.
20:30 (THU)
START
[ ]
Maintenance func
10. Set elec. consumption
12. Check touch key
Sel. Page [ ] Confirm
20:30 (THU)
11. Set touch key
9. Auto address
Auto address
Code no. O/D unit no.
Sel. Next
20:30 (THU)
1
A1
01_330918_EU_Eng.indb 59 2021/9/9 11:26:59
To Next Page
Loading...
