Panasonic S-25PY3E - How to Install Wireless Remote Controller; Note

46
Change the value by pressing the or button.
After changing all digits, press the button and proceed to
Step
5
.
5
Select one of the Setting Data “YYYY” by pressing the
or
button.
* Setting data “YYYY”
Setting data Flap position during operation
0000 Without separate setting
0001 Swing
0002 Move to position
1
and stay
0003 Move to position
2
and stay
0004 Move to position
3
and stay
0005 Move to position
4
and stay
0006 Move to position
5
and stay
NOTE
The flap swings during the operation under “Setting the Flap Separately”.
At this time, the unselected flaps are moved to the position 1
.
After selecting “Set data”, press the
button. (If setting continuously, follow the procedures
from Fig. A.)
If you wish to change the selected indoor unit or finish setting, press the button (the
display returns to Step
3
).
6
If the
button is pressed under the display Step
3
, the
following display (Detailed setting-end screen) appears.
Then select “YES” by pressing the
or button and press
the button.
8. HOW TO INSTALL WIRELESS REMOTE CONTROLLER
NOTE
Refer to the Installation Instructions attached to the optional Wireless Remote Controller.
Code no.
[ ][ ]
000001 - XXXXXX
0 X X
Set data 0001
0001
0 0 0
Code no.
000001 - XXXXXX
0 X X
Set data 0001
YYYY
0 0 0
]
Confrm
[ ][ ]
Detailed settings
[ ][ ]
Unit no.
Code no.
1-1
10
Set data 00010001
Exit detailed
settings
and restart?
YES
NO
Fig. C
Fig. D
1
2
3
4
5
Flap position
01_330918_EU_Eng.indb 46 2021/9/9 11:26:56