Panasonic S-25PY3E - Page 61

61
Auto Address Setting from the Wired Remote Controller
(CZ-RTC6 series)
(1) Keep pressing the
, and buttons simultaneously
for 4 or more seconds.
The “Maintenance func” screen appears on the LCD
display.
Maintenance func
XX / XX
[ ][ ]
ECONAVI
nanoeX
RC. setting mode
(2) Press the or button to see each menu.
Select “Auto address” on the LCD display and press the
button.
(3) The “Auto address” screen appears on the LCD display.
Select the “Code no.” to “A1” by pressing the
or
button.
After selecting “Code no.”, press the
button and proceed to Step (4).
If the button is pressed, proceed to Step (5).
(4) Select one of the “O/D unit no.” for auto address by pressing
the
or button.
After selecting “O/D unit no.”, press the
button.
Auto address
[ ]
O/D unit no. 1
Assigning
Auto address
[ ]
O/D unit no. 1
Searching
Auto address
Restarting
Automatic
transition
Automatic
transition
Approximately 10 minutes are required.
When auto address setting is completed, the units return to normal stopped status.
(5) If the
button is pressed under the display Step (3), the
following display (Auto address-end screen) appears.
Then select “YES” by pressing the or button and
press the button.
Maintenance func
XX / XX
[ ][ ]
Simple settings
Detailed settings
Auto address
Auto address
[ ][ ]
Code no.
O/D unit no.
A1
1
Auto address
[ ][ ]
Code no.
O/D unit no.
A1
1
Exit auto
address setup
and restart?
YES
NO
Auto address
]
Code no.
O/D unit no. 1
A1
Confrm
[ ][ ]
01_330918_EU_Eng.indb 61 2021/9/9 11:27:00