Panasonic SA-BT230P

13
4 Specifications
Main unit SA-BT230P/PC, SA-BT330P/PC
GENERAL
Power supply: AC 120 V, 60 Hz
iPod/iPhone Connector: DC OUT 5V 500mA MAX
WIRELESS LAN Connector: DC OUT 5V 500mA MAX
Power consumption: 90 W
Power consumption in standby mode:
0.5 W (BT330)
0.1 W (BT230)
Less than 0.1 W
Dimensions (WHD): 430 mm54 mm287 mm
(16 15/16”X2 9/64”X11 5/16”)
Mass (Weight): Approx. 3.2 kg (7.1lbs)
Operating temperature range: 0 C to 40 C
(+32 F to 104 F)
Operating humidity range: 35 % to 80 % RH
(no condensation)
AMPLIFIER SECTION
RMS TTL Power Output: 1000 W
1 kHz, 10 % total harmonic distortion
Front:
125 W per ch (3 )
Center:
250 W per ch (6 )
Surround:
125 W per ch (3 )
100 Hz, 10 % total harmonic distortion
Subwoofer:
250 W per ch (6 )
FTC TTL Power Output: 446 W
120 Hz to 20 kHz, 1.0 % total harmonic distortion
Front:
60 W per ch (3 )
Center:
106 W per ch (6 )
Surround:
60 W per ch (3 )
40 Hz to 120 Hz, 1.0 % total harmonic distortion
Subwoofer:
100 W per ch (6 )
Audio input
AUX x1
Digital audio input
Optical: x2
Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
Audio Format: PCM, Dolby Digital
FM TUNER SECTION
Frequency range:
87.9 MHz to 107.9 MHz (200 kHz step)
87.5 to 108.0 MHz (100 kHz step)
Antenna terminals: 75  (unbalanced)
VIDEO SECTION
Signal system: NTSC
Video output
Output level: 1.0 Vp-p (75 )
Output connector: Pin jack (1 system)
HDMI AV output
Output format:
1080p/1080i/720p/480p
Output connector: Type A (19 pin)
HDMI (Deep Color, x.v.Color
TM
, High Bit rate Audio)
This unit supports “HDAVI Control 5” function.
LASER Specification
Class I LASER Product
Wave length:
790 nm (CDs)/650 nm (DVDs)/405 nm (BDs)
Laser power:
No hazardous radiation is emitted with the safety protection
TERMINAL SECTION
USB:
USB 2.0 (Use for Wireless LAN Adaptor only)
Ethernet:
10BASE-T/100BASE-TX
1 system
SD card slot:
Connector : 1 system
Note:
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
Solder:
This model uses lead free solder (PbF).
Refer to their respective original service manuals for *1.