Panasonic SA-BT230P

75
Caution: Ensure the Regulator Diode (D5803) is tightly
screwed to the Heatsink Unit A.
Step 4 Solder pins of the Regulator Diode (D5803) on the sol-
der side of SMPS P.C.B..
Caution: Ensure pins of the Regulator Diode (D5803) are
properly seated before soldered onto SMPS P.C.B..
10.26. Disassembly of Fan
• Follow (Step 1) to (Step 6) of Item 10.3.
Step 1 Lift up the Wire Clamper.
Step 2 Detach the fan unit connector (CN5401) on D-Amp
P. C. B. .
Step 3 Remove 2 screws.
Step 4 Remove Fan Unit.