49
• Assembly of Panel P.C.B
Step 1 Solder the 4P cable to the connector (CN6001) on
Panel P.C.B..
Step 2 Dress 22P FFC according to diagram shown.
Step 3 Place the Panel P.C.B. onto the Front Panel.
Caution: Ensure that it is properly located & fully catched.
Step 4 Fix 5 screws.
Step 5 Dress 4P cable into the Front Panel’s ribs according to
diagram shown.
10.10. Dissassembly of Power Button
P.C.B.
• Refer to “Disassembly of Front Panel Block Assembly”.
• Disassembly of Power Button P.C.B.
Step 1 Remove 1 screws.
To Next Page
Loading...
