49
• Assembly of FL P.C.B.
Step 1 Solder 4P cable to the connector (CN6001) on FL
P. C. B ..
Step 2 Place FL P.C.B. onto Front Panel.
Caution: Ensure that it is properly located & fully catched.
Step 3 Dress 22P FFC (CN2002) on Main P.C.B..
Step 4 Dress 4P cable into Front Panel’s ribs & USB P.C.B.
according to diagram shown.
Step 5 Dress 4P cable flatly against the wall of Front Panel.
Step 6 Fix 4 screws to FL P.C.B..
8.10. Disassembly of Power Button
P.C.B.
• Refer to “Disassembly of Front Panel Block Assembly”
Step 1 Remove 1 screw.
To Next Page
Loading...
