80
10.3. Checking & Repairing SMPS
P.C.B.
Step 1 Remove Top Cabinet.
Step 2 Release the 3 tabs at the Bottom Chassis.
Step 3 Release the 2 tabs at each side of the Front Panel Block
Assembly in the direction of arrow.
Step 4 Slightly move Front Panel Block Assembly forward
according to diagram shown.
Step 5 Remove 1 screw.
Step 6 Twist the Wire Holder.
Step 7 Release Red (TL10) & Black (TL20) wires from the Wire
Holder.
Step 8 Remove AC Inlet P.C.B. as arrow shown.
To Next Page
Loading...
