65
Caution: During assembling, ensure that Power P.C.B. is
properly attached & fully connected to SMPS P.C.B..
8.22. Disassembly of SMPS P.C.B.
• Refer to “Disassembly of Power P.C.B.”
Step 1 Release the 2 tabs at each side of the Front Panel Block
Assembly in the direction of arrow.
Step 2 Release the 3 tabs at the Bottom Chassis.
Caution: Do not exert strong force when releasing the tabs.
Step 3 Detach the Front Panel Block Assembly slightly forward.
Step 4 Lift up the Wire Clampers.
Step 5 Detach 6P Cable wire at the connector (CN5400) on D-
Amp P.C.B..
Step 6 Detach 10P Cable wire at the connector (CN2004) on
Main P.C.B..
To Next Page
Loading...
