Panasonic TH-58PH10BK - Disassembly; Removal of Rear Cover; Removal of HU-Board; Removal of Slot Block

6 Disassembly
· To disassemble P.C.B., wait for 1 minute after power was
off for discharge from electrolysis capacitors.
·
and marks indicate screw positions.
6.1. Removal of Rear Cover
1. Remove screws (×12 , ×24 ) and then remove the Rear
Cover.
6.2. Removal of HU-Board
1. Remove 4 screws (A) and then remove the HU Terminal
Block.
2. Remove 4 screws (B).
3. Remove 3 screws (C) and then remove HU-Board.
6.3. Removal of Slot Block
1. Disconnect the connectors (DS2, DS4, DS6, DS7, DS8,
DS15).
2. Remove the Flexible Cable from the connector (DS1).
3. Remove 4 screws and then remove the Slot Block.
9
TH-58PH10BK / TH-58PH10EK