21
TH-65PF12EK
9 Disassembly and Assem-
bly Instructions
• To disassemble P.C.B., wait for 1 minute after power was off
for discharge from electrolysis capacitors.
• , , , , and marks indicate screw positions.
9.1. Removal of Rear Cover
1. Remove screws (×22 , ×4 , ×15 ) and then remove
the Rear Cover.
Note: when fixing the Rear Cover
• Screw on screws (*1, *2) firstly.
9.2. Removal of HDE-Board
1. Remove 4 screws (A) and then remove the HDE Terminal
Block.
2. Remove 4 screws (B).
3. Remove 2 screws (C) and then remove HDE-Board.
9.3. Removal of HL-Board
1. Remove 4 screws (D) and then remove the HL Terminal
Block.
2. Remove 4 screws (E).
3. Remove 2 screws (F) and then remove HL-Board.
9.4. Removal of Slot Block
1. Disconnect the connectors (DS2, DS4, DS6, DS7, DS8,
DS15).
2. Remove the flexible cables from the connectors (DS1,
DS3).
3. Remove 6 screws and then remove the Slot Block.
To Next Page
Loading...
