8 -$-2F250A-2831_E.fm Page 8 Tuesday. January 11.2005 12:20 PM ~ 8
-t C General Operation) :t
'0_-
14
~ Stereo/Bilingual Sound Selection Button 1,. Sound output modes can be selected by pressing the "Sound Selection" button.
STEREO, BILINGUAL (if transmitted) and MONO modes can be selected using this button.
Audio Signal Mode Indicator
STEREO CJ>
MAIN I I
SUB II II
MONO ';7
Type of broadcast Mode Indicator
Regular broadcast
N I d t ~
(Standard Audio) 0 n Ica or H v
Regular
+
~ NIGAM MONDl I H ';7
c
2 (MAIN I)
z
NIGAM STEREO CD H ';7
NIGAM DUAL MONO I -t II
(MAIN 1/ SUB II) L';7.J
-Regular broadcast .
; (Standard Audio) No Indicator H ';7
-+ ~ BILINGUAL or DUAL MONO I II
t~ : MAIN II SUB II H
N
C STEREO CD H ';7
Notes:
1. The "A2 (German)" stereo/bilingual TV sound transmission system is used in the following
countries; Australia, Malaysia, Thailand, Indonesia, etc. The "NIGAM" stereo TV sound
transmission system is used in the following countries; New Zealand, Singapore, Hong
Kong, Thailand, Ghina and Malaysia.
2. If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:
MONO automatic switching occurs, it is recommended you switch from STEREO to
MONO. When the broadcasting mode changes to "STEREO", or "MONO" after you have
selected "MONO" mode, change over "STEREO" mode will be made automatically.
3. Even when the contents of the receiving signal undergo changes, selection mode is kept
intact.
4. When the receiving conditions deteriorate, listening will be easier if the mode is set to the
"MONO" position, using the stereo/bilingual sound selection butlon.
5. "DUAL", also known as "DUAL MONO" or as "BILINGUAL" is not currently transmitled in
some countries.
~ 8 h
.~ -to
.",
To Next Page
Loading...
