Panasonic VL-SWD501 - Installing the Power Supply Unit (VL-PS240)

Installing the power supply unit (VL-PS240)
Power supply unit
(with cable covers removed)
〈AC cable〉
〈DC cable〉
45 mm
25 mm
7 mm
7 mm
〈Bottom view〉
〈Top view〉
AC cable
AC IN terminal
DC cable
binder hole
DC OUT terminal
Remove the screws (2) and then remove
the cable covers (1).
Connect the AC/DC cable to the AC IN
terminal/DC OUT terminal on the top and
bottom of the power supply unit, and then
secure the wires by tightening the screws.
AC cable
binder hole
DC cable
Screws
*1
*1
Cable binders
*1 Make sure that there are no bare
wires exposed outside the product.
Cable covers (1)
Screws (2)
How to connect the power cable (AC/DC)
Connect
the power supply unit and AC/DC cables.
Use the cable binders to secure the AC/DC
cables (double-coated area) to the power
supply unit.
Step 1
Strip the AC/DC cables as follows:
Step 2
Step 3
Step 4
Make sure to replace the cable covers (1).
Step 5
Power Supply Unit
Power Supply Unit
Installation
Installation