If your Video Intercom System includes a sub monitor, it can be used to easily check the signal status.
(If there is no sub monitor, use a camera.)
■Using the sub monitor to confirm
By taking the sub monitor to the installation site, you can confirm the signal status on the sub monitor’s screen.
■Using the camera to confirm
Temporarily connect the camera and the power supply unit to turn on the camera, and then register it to the main monitor.
Later, you can take the camera to the installation site and confirm the signal status using the camera’s indicator lamp.
Camera signal status
Strong Week Out of range
Lit
Green
Lit
Orange
Lit
Red
Flashing
Red
Install within this range
* Install a wireless sensor camera in a location where objects enter from side.
This will allow it to better detect the heat of the moving object.
Installation location for the wireless sensor camera
Installation location for the wireless sensor camera
Sub monitor signal condition
Strong Week Out of range
Install within this range
To Next Page
Loading...
