Attach the wall mount bracket to the wall that has the cable access hole and caulk the bracket.
1 Secure the wall mount bracket. 2 Use a water-resistant sealant to caulk around the
bracket, except for the bottom part.
•Mount the wall mount bracket so that the “UP” mark faces up, and caulk as shown here, making sure to
fill in any gaps. (If the bracket is not properly waterproofed, water may enter, which may result in fire or
electric shock.)
DC cable
Mounting screws x 4
Cable access
hole
83.5 mm
46 mm
Water resistant sealant
Wall mount
bracket
The bottom part of the bracket has a water
drain hole on it; do not caulk it
Install the wireless sensor camera
Step 1
Installing Wireless Sensor Cameras
Installing Wireless Sensor Cameras
To Next Page
Loading...
