Open the cover on the rear and connect the DC cable.
1 Open the cover.
2 Strip the DC cable.
Lift the tab
to open the
cover
Cover
12 mm
32 mm
Pass the DC cable through the
recessed area of the water-
resistant rubber and attach the
cable.
Water-resistant
rubber
4 Loosen the screws (2) and push in the wires of the DC
cable to the terminal connectors (non-polar), then
tighten the screws.
• Secure the water-resistant rubber attached to the cable
to its original position.
(1)
(2)
Install the wireless sensor camera
3 Remove the water-resistant rubber (1) from the wireless
sensor camera and attach it to the DC cable.
Step 2
Installing Wireless Sensor Cameras
Installing Wireless Sensor Cameras
To Next Page
Loading...
