122
When replacing the hard disk drive without
turning the power of the unit off
z Set the unit to the disk maintenance mode using the
"Maintenance" of "Maintenance".
→ The "HDD DISK MENU" will be displayed and the
unit becomes enable to replace hard disk.
x Move the cursor to select the hard disk drive to be
replaced and press the SET button.
→ The descriptions of how to replace the hard disk will
be displayed.
<selected extension unit in the RAID mode>
<selected extension unit in the HDD mode>
<selected the built-in hard disk>
Disk Info.
Version. Info.
c Replace the hard disk by following the displayed
descriptions.
After this step, the following steps are the descriptions
of how to replace the built-in hard disk of this unit.
Refer to the operating instructions of the extension unit
when replacing the hard disk in the extension unit.
v Replace the hard disk in the same way as described
from step 2 (1- 6) of “When replacing the hard disk
drive after turning the power of the unit off”.
b Press the SET button after completing the replacement
of the hard disk drive.
n When the built-in hard disk drive of this unit or the hard
disk drive of the extension unit in the SINGLE mode is
replaced, restart the unit.
After the restart, the "HDD DISK MENU" will be dis-
played automatically.
(When the hard disk drive of the extension unit in the
RAID 5 mode is replaced, this procedure ended in step
5.)
To Next Page
Loading...
