125
■ Hard Disk Initialization
It is necessary to initialize the hard disk at the following
conditions.
• When replacing the hard disk of this unit
• At the first operation after connecting the optional
extension unit to this unit
Important:
If the hard disk is initialized, all of the recorded images
will be deleted.
● Initialization of all hard disk (unit)
All hard disks including the internal hard disks and the hard
disks in extension units will be initialized. All units will be ini-
tialized at the RAID function activated.
z Turn on peripheral devices such as extension unit con-
nected to this unit.
x Turn on this unit and press the [SET] button after com-
pletion of system check.
Note:
• If the hard disk is changed or taken out, the top page of
the disk configuration menu automatically appears.
[Screenshot 1]
The top page of the disk configuration menu appears.
c Press the arrows button (A and B) to move the cursor
to "Format" and press the [SET] button.
[Screenshot 2]
The password entry screen appears.
v Press the camera selection button ([1]-[10/0]) and type
the password of Admin.
b Press the arrows button (C and D) to move the cursor
to "OK" and press the [SET] button.
[Screenshot 3]
The format screen appears.
n Press the arrows button (A and B) to move the cursor
to "All Format" and press the [SET] button.
Select "All Unit" at the RAID function activated.
<Screen at RAID function activated>
[Screenshot 4]
The setting screen of recording area appears.
m Press the arrows button (A and B) to select a record-
ing area and rotate the jog dial to set the capacity of
selected recording area.
For deciding the capacity of two or more recording
areas, repeat this procedure.
, Press the [SET] button after setting.
To Next Page
Loading...
