Panasonic WJ-HD316 - SPECIFICATIONS; General Specifications; Input;Output Specifications

153
General
SPECIFICATION
Power source:
Power consumption
Ambient operating
temperature
Ambient operating
humidity
Dimensions
Weight
Input/Output
Video
Audio
Others
*
1
When power is not supplied, video output signal was not sent from the unit even if video input signal is supplied.
*
2
Non-voltage N.O. Contact, 100 mA, +5 V pull-up
*
3
Open collector output, maximum under conditions of 24 V DC and 100 mA or less
*
4
High (+12 V, 6.3 mA)
*
5
30 KΩ, 5 V pull-up, –100 mA, N.O. Contact
*
6
5 V pull-up, –100 mA, Non-voltage N.O. Contact input
*
7
240 mA at maximum
*
8
Changeable with the mode switch
Video input connectors
Cascade input connector
Video output connectors
Monitor output connectors
Monitor output connector
(VGA)
S-video output connector
Video output connector
(front panel)
Audio input connectors
Expansion connector
Audio output connectors
Copy connectors
Control connectors
Alarm port
RS-485 ports
DATA ports
SERIAL port
Ethernet port
120 V AC, 50 Hz/60 Hz
85 W
+5°C to +45°C
Less than 90 %
420 mm (W) X 88 mm (H) X 350 mm (D) [16-9/16" (W) X 3-7/16" (H) X
13-3/4" (D)] (excluding rubber feet and projections)
9.5 kg (21 lbs.)
1 V [P-P] / 75 Ω, with auto termination loop-thru, vertical timing pulse mul-
tiplexed, x8 (1 to 8 CH) (BNC)
1 V [P-P] / 75 Ω, with auto-termination loop-thru,
x8 (9 to 16 CH) (BNC)
1 V [P-P] / 75 Ω (BNC)
1 V [P-P] / 75 Ω, active loop-thru output, x8 (1 to 8 CH) (BNC)*
1
1 V [P-P] / 75 Ω, active loop-thru output, x8 (9 to 16 CH) (BNC)
1 V [P-P] / 75 Ω, x2 (BNC)
RGB output, x1 (15-pin D-sub)
Y = 1 V [P-P] / 75 Ω, C-0.286 V [P-P] / 75 Ω, x1 (S-video output connec-
tor)
1 V [P-P] / 75 Ω, x1 (RCA pin)
–10 dB, 10 KΩ, x4 (RCA pin)
High-speed serial interface, 480 Mbps (theoretical value), x1
High-speed serial interface, 480 Mbps (theoretical value), x2
Emergency recording input*
2
, additional space warning output*
3
(for
devices connected to copy connectors), HDD trouble output*
3
, camera
trouble output*
3
, trouble output*
3
, electricity failure recovery completion
output*
4
, time adjust input/output*
5
, sequence switching input/output*
5
,
electricity failure detection input*
2
, external recording mode switching*
2
(25-pin D-sub) , +5 V output *
7
1 to 8 CH alarm input*
6
, 1 to 16 CH alarm input*
2
, 1 to 16 alarm output*
3
,
alarm recovery input*
2
, alarm suspension input*
5
(25-pin D-sub)
RS-485 (full duplex/half duplex*
8
), x2 (RJ-11)
RS-485, x2 (RJ-11)
RS-232C, x1 (9-pin D-sub)
10 Base-T/100 Base-Tx (RJ-45)
–10 dB, 600 Ω, unbalanced, x2 (RCA pin)