Panasonic WJ-ND400K - Page 51

51
Change the order of the registered camera
number (4-screen display)
1 Click the [Camera] button.
2 Click the [NW camera] tab.
The "NW camera setup" page will be displayed.
3 Select the camera channel numbers to be inter-
changed from the pull-down menu.
The combination of the camera channels to be used
for displaying images on a 4-screen are as follows.
Ch1 - Ch4, Ch5 - Ch8 … Ch57 - Ch60, Ch61 -
Ch64.
To change the combination of the camera channels,
change the order of the camera channel number by
interchanging the camera channel numbers.
The order of the camera channel number is also
applied to the sequence display.
4 Click the [Execute] button.
The camera channel number will be interchanged.
Important:
 • Whenthecamerachannelnumbersareinter-
changed, it will be applied to the following settings.
 • Emergencyrecording(page34)
 • Program(page43)
 • Networkinformation(page82)
Check/change the settings of the camera
manually
1 Click the [Camera] button.
2 Click the [NW camera] tab.
The "NW camera setup" page will be displayed.
Description about the button on the "NW camera
setup" page
[Setup] button: The setting items of the cameras
will be displayed in list form.
[Setup >>] button: The camera setup menu of the
recorder will be displayed.
[Camera setup page >>] button: The setup menu
of the camera will be called up and displayed.
Refer to the operating instructions of the con-
nected camera for information on how to config-
ure the settings of the camera.
Important:
 • Tocallupthesetupmenuofthecamera,itisneces-
sary to select "On" for "Port forwarding" on the
"Port forwarding" page. (Page 63)
 • Imagesmaynotbedisplayedwhendisplayingthe
setup menu of the camera.
 • Theusernameandpasswordentrieswillbe
required to control the camera.
3 Click the [Setup] button or the [Setup >>] button
of the camera of which the settings are to be
checked or changed.
The "Network camera registration setup" window
will be displayed. (The illustration shown below will
be displayed when the [Setup] button is clicked.)