28
When using PoE (IEEE802.3af compliant)
Connect a LAN cable (category 5 or better, straight, STP*) between a PoE device (such as a hub)
and the network connector of the camera.
* E models only.
IMPORTANT:
• Useall4pairs(8pins)oftheLANcable.
• Themaximumcablelengthis100m{328feet}.
• MakesurethatthePoEdeviceinuseiscompliantwithIEEE802.3afstandard.
• Whenconnectingboththe12VDCpowersupplyandthePoEdeviceforpowersupply,12V
DC will be used for power supply. Depending on the PoE device used, the power supply lamp
may not light and the network connections may not be possible. In this case, disable the PoE
device setting, and refer to the operating instructions of the PoE device in use.
• WhendisconnectingtheLANcableonce,reconnectthecableafteraround2seconds.When
the cable is quickly connected, the power may not be supplied from the PoE device.
Connection example when connecting to a network using a
PoE hub
<Required cable>
LAN cable (category 5 or better, straight, STP*)
* E models only
IMPORTANT:
• Thevideomonitorisusedforcheckingtheadjustmentoftheangularfieldofviewwheninstall-
ing the camera or when servicing. It is not provided for recording/ monitoring use.
• Useaswitchinghuborarouterwhichiscompliantwith10BASE-T/100BASE-TX.
• Powersupplyisrequiredforeachnetworkcamera.WhenusingaPoEdevice(hub),12VDC
power supply is unnecessary.
PoE device (hub)
PC
Speaker with amplier (option)
Microphone (option)
Speaker with amplier (option)
Microphone (option)