Panasonic WV-SP509 - Page 27

27
n Connect the power supply.
IMPORTANT:
 • The12VDCpowersupplyshallbeinsulatedfromthecommercialACpower.
 • Theoperatingsoundmightbeheardwhenthepoweristurnedon,howeveritdoesnotindi-
cate any malfunction.
When using 12 V DC power supply*
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from the
end of the wire, and twist the stripped part of the wire
sufficiently to avoid short circuit.
Specification of cable (wire): 16 AWG - 24 AWG
Single core, twisted
 • Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the 12 V DC power sup-
ply terminal on the rear of the camera.
* FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
IMPORTANT:
• Be sure to use the power cord plug provided with this product.
 • Besuretofullyinsertthepowercordplugintothe12VDCpowersupplyterminal.Otherwise,
it may damage the camera or cause malfunction.
 • Wheninstallingthecamera,makesurethatexcessiveforceisnotappliedtothepowercable.
 • BesuretouseanACadaptorcompliantwiththeSpecificationsregardingpowersourceand
power consumption (
☞ page 35).
(12 V DC)
(GND)
12 V DC power
cord plug
(accessory)
POWER
10BASE T/100BASE-TX
AUDIO OUT MIC/LINE IN
EXT I/O
SD CARD/ABF
MONITOR OUT
ACT LINK
12V = IN
GND 4 3 2 1
INITIAL
SET
ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/AUX OUT ALARM IN 2/ALARM OUT
To 12 V DC
power supply*
(This illustration represents
WV-SP509.)