Panasonic WV-SW458

13.5 Change the AUX name [Alarm]
Click the [Alarm] tab on the “Alarm” page. (®page 51, page 53)
The names of “AUX”, “Open” and “Close” on the “Live” page can be changed.
AUX title
[AUX (Up to 10 characters)]
Enter the name for “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: AUX
[Open (Up to 5 characters)]
Enter the name for “Open” of “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: Open
[Close (Up to 5 characters)]
Enter the name for “Close” of “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: Close
Note
• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.
For example, an operator can remotely control lights in a place where the camera is installed by
connecting the terminal to the light controller.
13.6 Configure the VMD settings [VMD area]
Click the [VMD area] tab on the “Alarm” page. (®page 51, page 53)
The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
IMPORTANT
• The alarm occurrence indication button (®page 18) will be displayed when motion is detected by the
VMD function.
• The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal
alarm or a command alarm.
• Depending on the network environment, notification may be delayed even when “Real time” is selected
for “Alarm status update mode” on the [Basic] tab of the “Basic” page (®page 57).
• Make sure to configure VMD area again if the setting for “Image capture mode” of the [JPEG/H.264]
tab or “Upside-down” of the [Basic] tab is changed after the VMD area has been configured.
132 Operating Instructions
13 Configure the alarm settings [Alarm]