IPv4 network
[Network Settings]
Select the method of how to configure the IP address from the following.
• Static: The IP address is configured by entering manually on “IP address(IPv4)”.
• DHCP: The IP address is configured using the DHCP function.
• Auto(AutoIP): The IP address is configured using the DHCP function. When the DHCP server is not found,
the IP address is automatically configured.
• Auto(Advanced): Using the DHCP function, network address information is referred to, and an unused
IP address is configured to the camera as a static IP address. The configured IP address is automatically
determined within the subnet mask range by the camera. When the DHCP server is not found, the IP
address is set to 192.168.0.10.
Operating Instructions 155
17 Configuring the network settings [Network]
To Next Page
Loading...
