3. Click the [Start] button to start recording images on the SD memory card. The SD recording status indicator
will light red (®page 18) while images are being recorded on the SD memory card.
The image saving interval can be configured on the [SD memory card] tab of the “Basic” page.
(®page 61)
4. Click the [Stop] button to stop saving images on the SD memory card.
→ The SD recording status indicator will turn off.
5. Click the [Close] button to close the window.
Note
• Image data saved on Drive B can be obtained by executing “Access img.” on the [SD memory card]
tab and logging in from the user authentication window (®page 70).
The destination to save image data is a fixed directory on Drive B. Refer to “Directory structure of drive
B” (®page 221).
• When the [Start] button is clicked immediately after the [Stop] button is clicked, saving of images may
not start. In this case, click the [Start] button again.
36 Operating Instructions
3 Record images on the SD memory card manually
To Next Page
Loading...
