12 Chapter 4: Connection
Chapter 4: Connection
This chapter guides you through the steps required to connect the IPR512 Receiver to your
network and how to power-up the unit. The IPR512 Receiver connects to your network
providing supervision for up to 512 Paradox control panels.
Connecting to the COM1 Port
The COM1 Port provides the connection from the IPR512 to the PC running the monitoring
station automation software. Its dedicated port output can be supervised through the ACK/
NACK protocol. The IPR512 Receiver is software compatible with monitoring station automation
software using Radionics 6500, Ademco 685, and Sur-Gard MLR2-DG reporting formats. For
more information, refer to “Software Compatibility” on page 6.
To connect to the COM1 Port
1. Connect the 3-meter (10-foot) DB25 connector to the COM1 (PC) port on the IPR512
Receiver.
2. Connect the other end of the cable to the COM Port of the PC or on the PC’s serial hub.
Figure 7: COM1 Port Connection
COM 1
(PC)
COM
2
(SERIAL OUT)
LAN WAN
1
WAN
2
INPUT
TRIGGER
C1
COM NO
OUTPUT
RELAY
I
O
PARADOX.COM
COM1 Connection
To Next Page
Loading...
Need help?
General
