Chapter 8: Initiating Communication with the IPR512 Receiver
57
Chapter 8: Initiating Communication with the IPR512 Receiver
Once the installation and configuration settings have been completed, the next step is to
register the Paradox reporting modules to the IPR512 Receiver.
Registering the Paradox Reporting Modules
No monitoring station operator action is required to register an Paradox reporting module.
Registration is initiated by the installer upon installation of the Paradox reporting module.
However, the monitoring station must provide the installer with the following information that is
entered by the installer.
• Account # for each partition of the site.
• IP Address and Port of the IPR512 Receiver(s) you wish that the site to report to.
• Receiver Password (1 to 32 digits). For more information on setting the Receiver Pass-
word, refer to “Receiver Configuration Menu” on page 30.
• Security Profile (2 digits). For more information on Security Profiles, refer to “Security Pro-
files Menu” on page 26.
Once the installer has entered this information, the installer then initiates communication with
the IPR512 Receiver and the Paradox reporting module will be automatically registered in the
receiver.
To Next Page
Loading...
Need help?
General
