User Codes and Labels Page 23
Deleting User Codes
To delete user codes, follow steps 1 to 3 in Programming
User Settings on page 24. In step 4, press [
CLEAR]. Once the
information is erased, press the [
ENTER] button three
times to save and exit.
Programming User Codes
The System Master and users with the Master feature can
program user codes along with user options and area
assignments. The section: Programming User Settings on
page 24 describes the steps you would follow to program
user codes. If you wish to program user codes using the
NEware Software, please contact your installer for
information.
If the keypad emits a rejection beep at any point during
the programming procedure, you may have chosen an
existing user code or you do not have access to certain
user options (see User Options on page 26 and Area
Assignment instructions in step 6 in Programming User
Settings on page 24). Regular users with the Master
feature (step 5 in Programming User Settings on page 24)
can only assign the same user options and area
assignments to which they themselves are assigned. For
example, if a User with the Master feature is assigned User
Option 1 and Area 2, they can only assign Option 1 and
Area 2 to a user code.
To Next Page
Loading...
