Testing and Maintenance Page 37
Chapter 10: Testing and
Maintenance
Burglar Alarm Testing
NOTE: It is important to disarm the system before testing the
alarm.
Two people are needed to complete this test. One person
will watch the screen on the keypad while the other
person walks around the protected areas and opens the
zones (i.e., opens the doors and windows that are
protected, walk in the path of the motion detectors, etc.).
The screen will display the opened zones, but if a zone
does not register, contact your installer.
Fire Alarm Testing
Do NOT use an open flame or burning materials to test
your fire detection devices. Your installer will provide
details on the best way to test your system.
System Maintenance
Under normal use your system requires no maintenance
other than regular testing. We recommend that your
installer change the battery every three years.
System Test
Speak to your installer before conducting a System Test
since the system must be programmed to respond to the
test instructions. It is normally recommended that you
conduct the system test once a week, but contact your
installer for instructions concerning your particular
system.
To conduct the system test:
1) Call your monitoring station to advise them that you
are testing your system.
2) Press [
MENU] > [9] SETTINGS > [6] COMMANDS > [1] TEST
REPORT.
3) Enter the master code.
To Next Page
Loading...
Need help?
General
