Page 28 Programming User Settings
Option [8]: Area Access
• When option [8] is ON, the keypad will permit access
to all the areas assigned to the user code.
• When option [8] is OFF, the keypad will only permit
access to the areas it controls. For example, the keypad
is assigned area 1 only, and your user code is assigned
areas 1 to 8. If the option is ON, you can access all eight
areas from the keypad. If the option is OFF, you can
only access area 1.
NOTE: By default all users can Regular arm the system.
Access Control User Options
Option [1]: Access Control
• When option [1] is ON, the user can gain access to an
access control door when Access Control is enabled in
the system. A user that is not assigned to any partition,
but has the Access Control option (Option [1])
enabled, can now gain access to an access control
door, press [
MENU] > [8] UNLOCK DOOR and enter a user
code.
• When the option is OFF, the user cannot access an
Access Control door.
Option [2]: Can Disarm with Access Card
• When option [2] is ON, a user’s access control card can
unlock and disarm an armed access control door.
• When option [2] is OFF, follow the settings in option
[8] on page 29.
NOTE: For option [2] to function in the ON position,
option [5] “Arm Only” in the User Options must be
disabled (refer to User Options on page 26).
Option [3]: Card with Extended Unlocked
Period
• When option [3] is ON, “Extended Unlocked Period” is
enabled. “Extended Unlocked Period” refers to the
time period programmed into each access control
door by your installer that extends the unlocked time
of the door. For example, if your installer sets the
Unlocked period of the door to 30 seconds and the
To Next Page
Loading...
Need help?
General
