Programming User Settings Page 27
• When option [1] is ON and option [2] is OFF, the user
can program and modify user codes (P.I.N. only) and
user labels.
• When both options [1] and [2] are ON, the user has
Full Master rights. The user can create or modify user
codes, user options, user access control options,
access card numbers, remote control serial numbers,
user labels and area assignments according to their
own programming. For example, if the Full Master has
access to area 1 and option [4] (Bypass) only, the Full
Master user can only assign area 1 and option [4] to
other users in the system.
Option [3]: Duress
• When option [3] is ON, the Duress feature is enabled.
This feature is used when someone forces a user to
arm or disarm an area(s). By entering a user code
(P.I.N.) reserved for the Duress feature, the system will
arm or disarm the area(s), and then send a silent alarm
to the monitoring station.
Option [4]: Bypass
• When option [4] is ON, the Bypass feature is enabled.
This feature allows the user to deactivate zones when
arming the area(s).
Option [5]: Arm Only
• When option [5] is ON, the Arm Only feature is
enabled. The user can arm assigned areas with either a
card or code, but cannot disarm.
• When the option is OFF, the user can either arm or
disarm assigned areas.
Option [6]: Stay & Instant Arm
• When option [6] is ON, the Stay and Instant arm
features are enabled. The user can now Stay or Instant
arm their assigned areas.
Option [7]: Force Arm
• When option [7] is ON, the Force arm feature is
enabled. The user can now Force arm their assigned
areas.