Programming User Settings Page 29
Extended Unlocked Period to 15 seconds, a user code
with “Extended Unlocked Period” enabled will have a
total of 45 seconds to pass through the door.
Options [4] and [5]: Arming with Card
•Options [4] and [5] define the type of arming when
arming with an access control card. You can either
regular arm, stay arm, force arm, or disable the Arming
with Card feature.
Option [6]: Add Tolerance Window to Schedule
• When option [6] is ON, the Schedule Tolerance
Window feature is enabled. This feature extends a
user’s scheduled access period through an access
control door by the amount programmed by your
installer. For example, if the user’s assigned schedule
for the door is Monday to Friday from 9:00 a.m. to 5:00
p.m., and your installer sets the “Tolerance Window” at
one hour, the user with the “Schedule Tolerance
Window” enabled will be able to enter and exit one
hour before and after their scheduled time for that
door.
Option [7]: Code Follows Schedule
• When option [7] is ON, users can use their codes only
during their scheduled hours assigned in step 7 in
Programming User Settings on page 25.
• When the option is OFF, users can use their codes at
any time.
Option [8]: Card to Unlock and Code to Disarm
Option [8] functions only if option [2] in Access Control
User Options on page 28 is OFF.
• When option [8] is ON, a user can use an access
control card to unlock an armed access control door,
Input Value
Arming with card Feature
[4] [5]
Off Off Disabled
On Off Regular arm
Off On Stay arm
On On Force arm
To Next Page
Loading...
Need help?
General
