8 Reference & Installation Manual
Figure 2.4: PGM Connections
3.0 About Programming
When programming a MG-RCV3 that is connected to an Esprit security system, all
the programming sections detailed in this manual apply. When programming a MG-
RCV3 in stand-alone mode, only the sections detailed in Table 3.1 on page 9 apply.
Please note that a programming section is empty when the keypad’s [2
ND]
key flashes.
MGRCV3ES_EI01.fm Page 8 Wednesday, May 4, 2005 3:27 PM