Need help?Do you have a question about the Paradox Digiplex EVO EVO192 V7.11 and is the answer not in the manual?
General| Zones | 8 on board, expandable to 192 |
|---|---|
| Partitions | 8 |
| User Codes | 999 |
| PGM Outputs | 5 on board, expandable to 250 |
| Remote Firmware Upgrade | Yes |
| Expandable | Yes |
| Memory | 2048 events |
| Event Buffer | 2048 events |
| PGMs | 5 on board, expandable to 250 |
| Communication | Supports GSM/GPRS/IP reporting |
| Battery Backup | 7 Ah |
| Number of Zones | 8 (expandable to 192) |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Humidity | 5% to 90% non-condensing |
| Compatibility | Paradox EVO series |
Understanding limitations for guaranteed protection against emergencies.
Awareness of potential issues when using non-traditional phone systems.
Typographical conventions, installer, and master codes.
Step-by-step procedure to access the panel's programming mode.
Overview of partition settings for system configuration.
Accessing advanced system configurations and operational modes.
Programming keypads, wireless receivers, and remotes.
Worksheet for recording serial numbers of system components.
Configuring zone parameters, definitions, options, and report codes.
Selecting resistor values for EOL and tamper detection.
Assigning keyswitches to functions and partitions.
Programming PGM outputs based on event and feature groups.
Programming user access codes, partitions, and schedules.
Configuring doors for access control within the system.
Setting up primary and secondary access schedules.
Configuring backup schedules for system reliability.
Defining access levels based on combinations of doors.
Programming and configuring wireless sirens.
Configuring remote controls and button templates.
Configuring core system operational parameters.
Configuring dialer settings for communication.
Configuring system timings and communication parameters.
Programming the VDMP3 voice module for alarm notifications.
Connecting and configuring the PCS module via BabyWare.
Configuring IP/GPRS module options for connectivity.
Assigning labels to system partitions.
Setting up schedules for arming/disarming reports.
Adjusting timers for partition-specific functions.
Configuring partition arming and disarming behaviors.
Defining how partitions arm and disarm.
Configuring partition-specific special features.
Defining call directions for partition alarm events.
Configuring exit delay for special arming modes.
Programming specific report codes for system events.
Configuring report codes for system troubles.
Automatically programming default report codes.
Restoring software parameters to factory defaults.
Table of Ademco Contact ID report codes.
Configuring settings for specific keypad models.
Configuring PGM outputs and keypad beep settings.
Configuring settings specific to TM50 and TM70 keypads.
Assigning wireless zones to detectors.
Testing signal strength of wireless transmitters.
Programming 2WPGM activation/deactivation events.
Using special keys for programming zone and user labels.
Transferring configuration data using the memory key.
Calculating the total milliamp requirements for system devices.
Guidelines for combus installation and RTC battery replacement.
Categorization of system trouble conditions.
Configuring PCS module for EN50131 compliance.
Setting system options for EN50131 compliance.
Detailed descriptions of system options for compliance.
Configuring partition timers for EN50131 compliance.
To Next Page
