32 Programming Guide
26 = Software Access (VDMP3, IP100, WinLoad, BabyWare)
00 = Non-valid source ID
01 = WinLoad / BabyWare direct
02 = WinLoad / BabyWare through IP module
03 = WinLoad / BabyWare through GSM module
04 = WinLoad / BabyWare through modem
09 = IP100 direct
10 = VDMP3 direct
11 = Voice through GSM module
12 = Remote access
13 = SMS through GSM module
99 = Any software access
27 = Bus module event
00 = A bus module was added
01 = A bus module was removed
02 = 2-way RF Module Communication Failure
03 = 2-way RF Module Communication Restored
28 = StayD pass acknowledged
01 to 32 = Zone number
99 = Any zone number
29 = Arming with user
01 to 32 = User number
99 = Any user number
30 = Special arming
00 = Auto-arming (on time/no movement)
01 = Late to close
02 = No movement arming
03 = Partial arming
04 = Quick arming
05 = Arming through WinLoad / BabyWare
06 = Arming with keyswitch
99 = Any special arming
31 = Disarming with user 01 to 32 = User number
99 = Any user number
32 = Disarming after alarm with user
33 = Alarm cancelled with user
34 = Special disarming
00 = Auto-arm cancelled (on time/no movement)
01 = Disarming through WinLoad / BabyWare
02 = Disarming through WinLoad / BabyWare after alarm
03 = Alarm cancelled through WinLoad / BabyWare
04 = Paramedical alarm cancelled
05 = Disarm with keyswitch
06 = Disarm with keyswitch after an alarm
07 = Alarm cancelled with keyswitch
99 = Any special disarming
35 = Zone bypassed 01 to 32 = Zone number
99 = Any zone number
36 = Zone in alarm
37 = Fire alarm
38 = Zone alarm restore
39 = Fire alarm restore
40 = Special alarm
00 = Panic non-medical emergency
01 = Panic medical (this panic alarm is not UL approved)
02 = Panic fire
03 = Recent closing
04 = Global shutdown
05 = Duress alarm
06 = Keypad lockout (Partition 1 only)
99 = Any special alarm event
41 = Zone shutdown 01 to 32 = Zone number
99 = Any zone number
42 = Zone tampered
43 = Zone tamper restore
Event Group # Sub-group #
To Next Page
Loading...
Need help?
General
