Serial Communications A-3
DC590+ DRV Series DC Digital Drive
NOTE When transferring a UDP configuration file from version of the 590 or 590P earlier than 8.1 then the following parameters are ignored:
Tag Block Parameter
18 AUTOTUNE AUTOTUNE
120 MENUS ENTER PASSWORD
138 MAIN PORT (P1) GROUP ID (GID)
139 MAIN PORT (P1) UNIT ID (UID)
140 AUX PORT (P2) GROUP ID (GID)
141 AUX PORT (P2) UNIT ID (UID)
142 MAIN PORT (P1) PNO.7
143 AUX PORT (P2) PNO.7
144 MAIN PORT (P1) CHANGEBAND (BIN)
145 AUX PORT (P2) CHANGEBAND (BIN)
146 MAIN PORT (P1) ENABLED
147 AUX PORT (P2) ENABLE
148 MAIN PORT (P1) MODE
149 AUX PORT (P2) MODE
150 MAIN PORT (P1) BAUD RATE
151 AUX PORT (P2) BAUD RATE
152 MAIN PORT (P1) ESP SUP.(ASCII)
153 AUX PORT (P2) ESP SUP.(ASCII)
158 MAIN PORT (P1) ERROR REPORT
159 AUX PORT (P2) ERROR REPORT
303 MAIN PORT (P1) OPTION VERSION
328 SYSTEM PORT (P3) ESP SUP.(ASCII)
331 SYSTEM PORT (P3) CHANGEBAND (BIN)
332 SYSTEM PORT (P3) ERROR REPORT
333 SYSTEM PORT (P3) PNO.7
334 MAIN PORT (P1) PARITY
499 MAIN PORT (P1) OPTION ADDRESS
536 SEQUENCING REM.SEQUENCE
543 CALIBRATION ZERO CAL INPUTS
555 CALIBRATION SCALE CAL INPUTS
609 AUTOTUNE METHOD
UDP XFER (TX)
This is the transfer of the drive’s settings as an Intel Hex file.
1. Connect the Drive to the host using the appropriate lead.
2. Using a standard communications package prepare the host to receive an ASCII file. Remember to set up the host's serial port first.
3. On the host computer, direct data received on the serial comms port to a file.
4. Start the transfer on the Drive by selecting UDP XFER (TX) on the MMI and pressing the UP (↑) key, as instructed. The drive says
SENDING.
5. When the transfer is finished, terminate the capture of serial data on the host computer.
To Next Page
Loading...
