Programming D-97
DC590+ DRV Series DC Digital Drive
PROFILED GAIN
This function block may be used to profile the proportional gain input to the PID block.
100.0%
PROFILED GAIN
Parameter Tag Range
PROP. GAIN 404 0.0 to 100.0
The nominal gain prior to profiling.
MIN PROFILE GAIN 474 0.00 to 100.00 %
This expresses the minimum gain required at minimum diameter (core) as a percentage of the (maximum) P gain at full diameter (100%), when
MODE > 0.
DIAMETER 709 0.00 to 100.00 %
The actual measured diameter. If appropriate, this may be connected to the DIAMETER output parameter in the DIAMETER CALC function block.
MIN DIAMETER 710 0.00 to 100.00 %
Set to the minimum core diameter (normally the empty core diameter) as a percentage of the maximum roll diameter. If appropriate, this may be
connected to the MIN DIAMETER parameter in the DIAMETER CALC function block.
To Next Page
Loading...
